Easy Open Kit

The EAS999 system is intended for use in situations needing installation convenience, and where individual doors or cabinets need added security coupled with ease of use. A kit can be fitted easily. Each door controller is then set to recognise a number of TinyTags. TinyTags can be authorised in as many door controllers as you like. This would allow the same tag to unlock the front door, back door and office door - which could be in a different building- for example.

Products available are EAS999, EAS999K, EAS999_MAG, each supplied with 3 TinyTags and a Master. Additional TinyTags can be ordered separately. Details below :-

Electronic controller.
Mounting box
Brushed aluminium surface case

Note these first three items are mounted together on the inside of the door and the controller requires a DC power supply of 10.5-14V DC

Reader that is mounted on the front side and attractive self-adhesive reader cover
One Master TinyTag which you use to authorise access with the everyday TinyTags.
Three everyday TinyTags, mounted in key ring fobs.
Full and explicit installation instructions.

The EAS999K

As EAS999 listed above.
Slim line maglock with Z&L brackets to mount magnet above inward opening doors.

Note this pack requires a DC power supply of 10.5-14V DC

Optional Extras

The PT_TTE Touch to Exit unit.

"Touch to Exit" unit, single gang, brushed stainless steel faceplate to match EasyOpen.
A 1GSLV surface case is also available for surface mounting the PT_TTE. The case is 38mm deep and has a brushed aluminium finish to match EasyOpen.

This module is required to convert the EAS999 system into the "Managed System" and enables a link between the door controller and a PC computer. Using this module and the software supplied significantly increases the features and benefits of having the EAS999 system fitted.

The EAM232A unit comprises :-

232 adapter board (shown)
RS232 connector cable, jack plug to 9 way D-type
Open Access Manager software on CDROM

The EAM232A adapter board is connected to the EAS999 controller PCB using a simple installation procedure.

SPECIFICATIONS
Operating Voltage	5V DC (Powered from EAS999)
Monitor input	Short to ground
Current consumption	100mA
Anti-tamper	Automatic
Mounting	16-way plug mates with 16-way socket on EAS999
RS232 connections	3.5mm jack socket OR screw terminals
Connection to a PC	The EAM232A can be connected to a PC using the serial cable provided. One end of the cable is fitted with a 3.5mm jack plug, which should be pushed into the socket on the EAM232A, and the other end is fitted with a 9-way D-type socket, which should be pushed into a free COM port on the PC. Alternatively, a hardwired connection can be made to the screw terminals on the EAM232A adapter.

To programme the EasyOpen unit it is necessary to present TinyTags to the reader and look at the display on the front of EasyOpen simultaneously. With some installations this is difficult or impossible. Coastform systems have recognised this problem and designed a simple low cost solution.
The auxiliary reader solves this problem, plugging directly into the EasyOpen controller and allowing programming from directly in front of the controller. Programming works as normal but TinyTags are presented to the auxiliary reader rather than the main reader. The main reader is automatically disabled while the auxiliary reader is plugged in.

For regular use it may be best to drill a hole in the bottom of the surface case of the controller, so that the auxiliary reader can be plugged in without removing the faceplate.

The EasyOpen Range

The EAS999K

Optional Extras

The PT_TTE Touch to Exit unit.