EasyOpenKit

	EAS999 PCB mounted on brushed stainless steel faceplate.
	Mounting Box	Reader cover, self-adhesive
	Brushed aluminium surface case	Master
	Brushed aluminium surface case	Everyday TinyTags

EAS999 SPECIFICATIONS

Operating Voltage (Max)	12V DC (10.5V to 14V)	Request to exit / EXIT SWITCH connector	.
Current consumption	100mA	Terminal: “+VDC Out”, “+”	Connected directly to the power supply positive rail
Output current drive	(Tag 6, 7) : 1A (source, from the power supply positive rail) (Tag 8) : 2A (sink to gnd)	Terminal: "Req EXIT”, “N/O”	Input from egress button, operates with short-to-gnd, N/C, N/O CAUTION: Input range: 0V to +5V MAX.
Reader cable	Do not exceed 3m length	Reader frequency	125KHz
Reader mounting	Do not mount directly onto metal. Do not mount any 2 readers within 60cm of each other	Reader range	60mm max.

The EAS999 can be used as an authorisation mechanism for other systems. Tag6 and Tag7 boards can source 1A from the terminal marked “Lock”. Tag8 boards are capable of directly sinking 2A at the terminal marked “L-” on the “Lock” connector; this terminal can withstand backfed voltages from other systems of 30V. The terminal marked “L+” on Tag8 boards is connected directly to the power supply positive rail. This makes the Tag8 boards capable of driving many other systems, including some which normally require a voltage free contact to short the input to gnd to operate.

EAS999 CONNECTIONS

DO NOT OVER TIGHTEN CONNECTIONS TO EAS999

Fix the mounting box and surface case. Note position of 2 closely spaced lugs at bottom of surface case. Feed all wires through gland holes into the box.

connect the reader

connect the lock

connect the power - 12V DC supply from plug-top PSU, CSPS12VSS PSU, or CSPS12VBB PSU with battery backup. EAS999 will not operate if polarity is reversed !

connect TOUCH TO EXIT if fitted

connect EGRESS BUTTON if fitted

Installing EasyOpen Access Control

EAS999 PARTS LIST

EAS999 SPECIFICATIONS

EAS999 CONNECTIONS